Self-Standing Installation
Follow the steps below to install the charging station on a hard and level floor.
Place the floor stand dock on a hard and level floor and assemble the floor stand pipe.
Clip the power cord tidily into the cord keeper a on the back of the floor stand pipe.
Slide the detachable nozzle storage onto the floor stand pipe.
Make sure not to pinch or tangle the power cord behind the mop pads storage.
Assemble the charging station onto the top of the floor stand pipe.
Connect the power adapter to the port on the back of the charging station.
Drill a hole in the wall and insert the drywall anchor b if needed.
Before drilling, make sure that there are no pipes or electrical wires inside the wall at the desired location.
For drywall anchor: use 1/4″ (6.5 mm) drill bit
For concrete or wall stud: use 1/8″ (3 mm) drill bit
If screwing into drywall, use the drywall anchor.
Align the wall anchoring block c of the charging station, and fix the charging station to the wall by tightening the anchoring screw d all the way.
Plug the power cord into the power outlet.
The charging station can be removed as needed. To remove it, hold the floor stand dock steady and pull up on the charging station.
Using Double-Sided Tape to Secure the Appliance
Use the double-sided tape a to attach the wall anchoring block b to the charging station.
Remove the centre section of double-sided tape before attaching it to the wall anchoring block.
Attach the second piece of double-sided tape to the other side of the wall anchoring block to secure it to the wall.
Do not use double-sided tape on wallpaper.
