Enhancing the Heating Function (On Some Models)
If the heating function is not sufficient to warm the room, this function uses the heat of the compressor to enhance the heating function.
If the installer setting mode is not set correctly, it can cause problems with the product, injury or property damage. This mode must be set by an authorized installer, and any installation or change that is carried out by an unauthorized person should be responsible for the results.
Press and hold the JET MODE and RESET buttons simultaneously.
Release the RESET button.
When OO appears on the display screen, the product is in the installer setting mode.
Release the JET MODE button.
Press the a button repeatedly until 6 appears on the remote control.
Press the b button to select the desired setting according to the table.
Setting Code
Setting Temperature
Comp On
Comp Off
0
Default
1
7 8 (4 7)
11 8 (6 7)
2
4 8 (2 7)
7 8 (4 7)
3
-2 8 (-1 7)
2 8 (1 7)
Press the t button on the remote to turn the indoor unit on.
Press RESET button to use the general operation mode.
This function only takes effect when the product is in the Heating mode.