Four-Wire Power Cord

A UL-listed strain relief is required.
Use a 30-amp, 240-volt, 4-wire, UL-listed power cord with #10 AWG-minimum copper conductor and closed loop or forked terminals with upturned ends.

• Remove the terminal block access cover on the upper back of the appliance.

• Install UL-listed strain relief into the power cord through-hole.

• Thread a 30-amp, 240-volt, 4-wire, UL-listed power cord with #10 AWG-minimum copper conductor through the strain relief.

  

  1. Terminal Block

  2. UL-Listed Strain Relief

  3. UL-Listed 4-Wire Power Cord

• Transfer the appliance's ground wire from behind the green ground screw to the center screw of the terminal block.

  Warning

  • This appliance is supplied with the neutral wire grounded. This white ground wire MUST BE MOVED to the neutral terminal when a 4-wire cord is to be used, or where grounding through the neutral conductor is prohibited.

• Attach the two hot leads (black and red) of the power cord to the outer terminal block screws.

• Attach the neutral (white) wire to the center screw of the terminal block.

• Attach the power cord ground wire to the green ground screw.

• Tighten all screws securely.

• Reinstall the terminal block access cover.

  

  1. White Wire moved from Ground Screw

  2. Hot Leads of Power Cord (Black and Red)

  3. Neutral Wire (White)

  4. Power Cord Ground Wire

  5. Ground Screw