Top > INSTALLATION > Final Installation Check > Test Exhaust System

Test Exhaust System

Once you have completed the installation of the appliance, use this test to make sure the condition of the exhaust system is adequate for proper operation of the appliance. This test should be performed to alert you to any serious problems in the exhaust system of your home.

  • Your appliance features Flow Sense, an innovative sensing system that automatically detects blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use.

    Note

    • The appliance should be cool before starting this test. If the appliance was warmed up during installation, run the Secado con Aire (Air Dry) cycle for a few minutes to reduce the interior temperature.

Activating the Installation Test

  • Remove the drying rack and literature, and then close the door.

    • Do not load anything in the drum for this test, as it may affect the accuracy of the results.

  • Press and hold the Temp. and Alarma (Signal) buttons and then press the Encendido/Apagado (Power) button.

    • This button sequence activates the installation test. The code 1Ns will display if the activation is successful.

  • Press the Inicio/Pausa (Start/Pause) button.

    • The appliance will start the test, which will last a few minutes. The heat will be turned on and the temperatures in the drum will be measured.

  • Check the display for results.

    • During the test cycle, monitor the Flow Sense display on the control panel. If no bars are displayed when the cycle ends, the exhaust system is adequate. If the exhaust system is severely restricted, the display will show four bars. Have the system checked immediately, as performance will be poor. Other problems may also be shown with error codes. Refer to the the Error Code table for details and solutions.

  • End of cycle.

    • At the end of the test cycle, ENd will display. The test cycle will end and the appliance will shut off automatically after a short delay.

Check the Duct Condition

If the Flow Sense LED is turned on, check the exhaust system for restrictions and damage. Repair or replace the exhaust system as needed.

Note

  • When the appliance is first installed, this test should be performed to alert you to any existing problems with the exhaust duct in your home. However, since the test performed during normal operation provides more accurate information on the condition of the exhaust duct than the installation test, the number of bars displayed during the two tests may not be the same.

  • Do not interrupt the test cycle, as this could result in inaccurate results.

  • Even if no bars are displayed during the test cycle, some restrictions may still be present in the exhaust system. Refer to the Venting the Dryer section of this manual for complete exhaust system and venting requirements.

Error Codes

Check the error code before you call for service.

Error Code

Possible Cause & Solution

tE1 or tEz

Temperature snesor failure.

  • Turn off the appliance and call for service.

Hs

Humidity sensor failure.

  • Turn off the appliance and call for service.

Ps, PF, or NP

Electric dryer power cord is not connected correctly, or house power supply is incorrect.

  • Reset circuit breaker or replace fuse. Do not increase the fuse capacity.

House fuse is blown, circuit breaker has tripped, or power outage has occurred.

  • If the problem is a circuit overload, have it corrected by a qualified electrician.

GAs

Gas supply or service turned off. (Gas Model only.)

  • Confirm that house gas shutoff and the dryer gas shutoff are both fully open.

Restricted or Blocked Airflow

Avoid long runs or runs with multiple elbows or bends.

Excess or crushed transition duct

Too many elbows or exhaust too long

Check for blockages and lint buildup.
Make sure the ductwork is not crushed or restricted.