Preparing Door Panel

• Mark a centre line lengthwise down the back of the door panel.

  

• Align the top and centre line on the installation template with the top and centre line of the door panel. Securely tape the installation template to the back of the door panel.

  

• (Case A) Mounting the sliding panel

  Use a 2 mm diameter drill bit to drill 10 mm deep pilot holes at the 12 points marked on the template.

  

  (Case B) Mounting the fixed panel

  Use a 2 mm diameter drill bit to drill 10 mm deep pilot holes at the 10 points marked on the template.

  

• Remove the template, and attach the upper and middle panel brackets (provided) to the door panel using the provided bracket screws (Φ 4 x 14 mm).

  

  (Case A) Mounting the sliding panel

  Attach the lower panel brackets (provided) to the door panel using the provided bracket screws (Φ 4 x 14 mm).

  • Position the lower panel brackets with the flat side facing out.

  

• Attach a handle to the front of the door panel before mounting the panel on the dishwasher. Make sure to countersink the screws so the panel slides smoothly.