Connecting the Hose to the Water Tap
Connect the water supply hose a to the water tap.
Do not shorten or damage the water supply hose as it contains electrical wires and components. It can not be detached or removed from the appliance for installation purposes.
It is important that the water supply hose not be tampered with, cut, disassembled, pulled, or kinked. It contains electrical wiring inside and if damaged, can cause an electrical hazard.
Only use the threaded nut of the water supply hose to tighten it to the tap.
Do not twist or kink the water supply hose when connecting it to the tap.
This appliance may be fed with either hot or cold water. If the water connection can not be maintained below 65ºC, the appliance must be connected to cold water.
Use sealant tape or sealing compound on the tap’s thread to avoid water leaks.
Make sure that the line is not kinked or sharply bent.
Before connecting the water supply hose to the tap, turn on the tap to flush out foreign substances (dirt, sand or sawdust) in the water lines. Let water drain into a bucket.
It takes about 3 – 4 minutes for the first supply water.