Note for Connection

Water pressure must be between 50 kPa and 800 kPa (0.5‒8.0 kgf/cm²). If the water pressure is more than 800 kPa, a decompression device should be installed.Periodically check the condition of the water supply hose and replace the water supply hose if necessary.Do not overtighten the water supply hose or use mechanical devices to tighten onto the inlet valves.No further backflow protection required for connection to the water inlet.

Checking the Rubber Seal

Two rubber seals a are supplied with the water supply hose. They are used to prevent water leaks. Connection to taps is sufficiently tight.Do not use mechanical devices such as multi grips to tighten the water supply hose. Ensure that the curved end of the water supply hose is connected to the appliance.

Connecting the Hose to the Water Tap

Screw the supply hose connector onto the water supply tap. Hand tighten only with the aid of a soft cloth. Do not overtighten the supply hose with any mechanical device.After connecting the water inlet hose to the water tap, turn on the water tap to flush out foreign substances (dirt, sand, sawdust, and etc.) in the water lines. Let the water drain into a bucket, and check the water temperature.

Connecting the Hose to the Appliance

Screw the supply hose to the water inlet valve on the back of the appliance.Do not connect the hose to the hot water supply for models with one water inlet. Connect to the cold water supply only.After completing connection, if water leaks from the hose, repeat the same steps. Use the most conventional type of tap for the water supply. In case that the tap is square or too big, remove the guide plate before inserting the tap into the adaptor.Make sure that the hose should not be kinked or trapped.