Flooring

• To minimize noise and vibration, install the washer on a level, solidly constructed floor capable of supporting the washer without flexing or bouncing.

• The washer must be installed on firm flooring to minimize vibration during the spin cycle. Concrete flooring is best, but a wood floor is sufficient, provided it is built to FHA standards.

• The floor under the washer must not slope more than 1 inch (2.5 cm) from front to back or side to side.

• Installing on carpeting and soft tile surfaces is not recommended.

• Never install the washer on a platform or weakly supported structure.

Floor Installation

To ensure sufficient clearance for water inlet hoses, drain hose and airflow, allow minimum clearances of at least 1 inch (2.5 cm) at the sides and 4 inches (10 cm) behind the washer. Be sure to allow for wall, door, or floor moldings that may increase the required clearances.

Dimensions and Clearances
A	45'' (114.3 cm)
B	25 1/5'' (64 cm)
C	4'' (10 cm)
D	1'' (2.5 cm)
E	24'' (60.96 cm)
F	1/4'' (0.5 cm)