Top > OPERATION > Options and Extra Functions

Options and Extra Functions

Select the desired cycle and then select the options for that cycle.

Contains Topics

Delay Start

This feature delays the start of a selected cycle. Each time the Delay Start button is pressed, the delay time increases by an hour. The delay time can be set from 1 to 24 hours, in one-hour increments.

High Temp.

The indicator lights up and the dishwasher increases the main wash temperature to 158 °F (70 °C). Helps to remove the oil on the tableware more effectively.To turn off the high temperature function, press the High Temp. button again.

Sani Rinse

Press the Sani Rinse button to activate the function, the indicator light will remain on, and the final flushing water temperature will increase to 155 8 (68 7) and remain at that temperature for 10 minutes.To turn off the function, please press the Sani Rinse button again. The function will be turned off and the indicator light will turn off.

Using Auto Open Dry

It can be used for all cycles except Rinse. When Air Dry is selected, the cycle time will be shortened, and the dishwasher will operate in residual heat drying mode with the door opening automatically at the end of the cycle.It can be used for all cycles except Machine Clean and Rinse. When Heat Dry is selected, the time will be extended and the temperature of the final rinse will be increased to help improve the drying effect.When neither Air Dry nor Heat Dry is selected (indicator lights off), the dishwasher runs the Residual Heat mode, and the door will not open automatically.

Control Lock

This feature helps prevent settings from being changed during a cycle. Selecting this feature locks all of the buttons, except for the Control Lock button, on the control panel. This feature does not lock the door.Unlock indicates that the control lock is disabled, and Lock indicates that the control lock is enabled.Press and hold Control Lock for 3 seconds to switch the control lock status.To start a new cycle, deactivate this feature.

Cycle/Option Guide

The cycle guide below shows the available options for each cycle.CycleAutoHeavyNormal*TurboMachine CleanRinseWater Usage(L)6.8 - 16.716.76.5 - 2010.49.53.5(gal)1.80 - 4.414.411.72 - 5.282.752.510.93Wash Time with Options (Mins.)87 - 220145 - 21085 - 23050 - 157120 - 17615Available OptionsSani Rinse####High Temp.###Air Dry*#####Heat Dry####Residual Heat (Door Closed)#####* Default settingActual water consumption will vary depending on soil level and hardness of water.The actual running time and cycle time displayed may change depending on options chosen, soil level, water temperature, and hardness of water. Therefore, display time and actual running time can be different.

Using the Option Setting Mode

Ensure the program is selected.Press Rinse a and Delay Start b at the same time for 5 seconds.Refer to the table to set up each function.Press START c to save.FunctionButtonDisplayRinse Aid LevelDelay Startd3 ~ d4 ~ d5 ~ d6 ~ d7 ~ d8 ~ d9 ~ d0 ~ d1 ~ d2Rinse Aid LevelAdjust the level of rinse aid from d0 to d9.For more information, refer to the Rinse Aid Dispenser Adjustment section.