Using the Wet Mop Pads

Press the Power button. You can use the only mop mode and not turn on the dust suction function.

Press the ~ button to turn on the dust suction function.
Press the ! button once while pressing the ~ button once to turn off the dust suction function.

Caution

Do not assemble or disassemble the nozzle while the appliance is turned on. Doing so may result in injury.
Set the water adjustment button to the STOP position when not using the appliance for an extended period of time. Failure to do so may result in product failure.
Do not let the appliance stand on the floor while the wet mop pads are attached. Doing so may result in damage or swelling to wood flooring.
Do not use on PVC or PU mat for infants or children. Friction can cause the motor to overheat.
If you use the mop nozzle for a long time with the suction off, the motor may overheat (recommended duration of use: 80 minutes). When the moter overheats, the overheating prevention function is activated and the appliance is automatically turned off. Use the appliance after cooling the heat for about one hour in a cool, well-ventilated place.

Press the PUSH button a to remove the water tank from the mop nozzle.
Open the water inlet cap b of the water tank and fill the tank with water.
- Do not put liquid other than water and hot water in the water tank.
Close the water inlet cap tightly.
- If the water inlet cap is not closed properly, water may leak.
Attach the water tank to the mop nozzle again.
- Insert the 2 tabs c at the front of the water tank into the slots d on the top of the mop nozzle. Press down at the centre e to lock the tank in place.

Wet both sides of the mop pads with water then squeeze out any excess water before attaching the pads.
- Do not attach pads while they are dripping wet.
- Attaching and using mop pads while they are dry may affect the cleaning results.
Place the mop nozzle upside down on the floor.
Align and attach the centre of the mop pad with the centre of the mop attachment plate.
- Attach the Velcro on the mop pad to the mop plate. Attaching the mop pad upside down or improperly may affect the cleaning results.
Assemble the mop nozzle to the appliance.

Slide the water adjustment slider button to adjust the amount of water released onto the mop pad to either High Mode or Low Mode.

	High Mode : Slide the slider button to clean ingrained dirt or supply a large amount of water.
	Low Mode : Slide the slider button to supply a small amount of water for cleaning wood or other flooring that can be damaged by too much water.
	STOP : Position the slide button in the center. This stops the supply of water so you can go over areas that are already wet.

Warning

To avoid injury, do not attach the mop pad while the mop attachment plate is rotating.

Caution

Do not let the appliance stand on the floor while the wet mop pads are attached. Doing so may result in damage or swelling to wood flooring.

Attach the water tank and mop pads to the mop nozzle.
Slide the water adjustment slider button to adjust the amount of water released onto the mop pad to either High Mode or Low Mode.
Press the Power button to start cleaning.