Installation Location
Do not install the appliance around a heat source. The rear side of the appliance must be well ventilated. Failure to follow these instructions may result in problems.
The appliance is not designed for maritime use or for use in mobile installation such as caravans, aircraft and etc.
Do not install the appliance as a built-in appliance. It is not suitable for built-in purpose.
For better drying performance, keep the rear of the appliance away from the wall.
Make sure that the location where the appliance will be installed meets a minimum clearance conditions.
Install the appliance on a flat hard floor. Allowable slope under the appliance is 1 degree.
Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar materials under the appliance.
Install the appliance in a location where service engineers are easily accessible in the event of a breakdown.
Do not install the appliance next to high-temperature appliances such as refrigerator, oven or stove, and etc. It can cause poor drying performance and delay programme duration. It also adversely affect the proper functioning of the compressor.
Do not install the appliance where there is a risk of frost or dust. The appliance may not be able to operate properly or may be damaged by freezing of condensed water in the pump and drain hose.
With the appliance installed, adjust all four feet using a spanner to ensure the appliance is stable, and a clearance of approximately 20 mm is left between the top of the appliance and the underside of any work-top.
A | 100 mm |
B | 20 mm |