Top > INSTALLATION > Installing the Oven > Instructions

Instructions

This oven must only be installed by a licensed electrician. The installer is responsible for the correct electrical connection of the appliances and the observance of the relative safety codes and recommendations.

Warning

  • The oven should be connected to the electricity supply by means of a proper circuit breaker or fuse. Never use multiple plug adapters or extension leads.

  • This connection may be achieved by having the plug accessible or by incorporating a switch in the fixed wiring in accordance with the wiring rules. Failure to do so can result in a fire.

Note

  • The oven must be installed in compliance with the manufacturer’s instructions. For more information about installation, please refer to the installation manual.

Safety Instructions for the Installer

  • During installation, ensure that no persons can come into contact with live components.

  • The oven must be installed by a qualified professional electrician, in accordance with the corresponding regulations and standards.

  • The oven is a heavy appliance and must be transported with great care.

  • Before initial use, remove all packaging, both external and from inside the appliance.

  • No modification may be made to the oven’s technical characteristics.

  • To operate this appliance safe, please be sure that it has been installed to a professional standard respecting the installation instructions. Damages occur because of incorrect installation are not within the warranty.

  • While doing the installation, please wear protective gloves to prevent yourself from getting cut by sharp edges.

  • Check the appliance if there is any damage before installation and do not connect the appliance if there is.

  • Before turning on the appliance, please remove all the packaging materials and adhesive film from the appliance.

  • Lift the appliance and place it inside the housing unit.

    Caution

    • Do not lift the appliance by the door handle to avoid potential damage to the glass and hinges.

  • Fix the appliance to the housing unit using 2 screws 07a a. Cover both screws with rubber pads 07b b.

    • Hand-tight only. Do not use power drill to avoid damage to the screw.

    1. 07a

    2. 07b

  • Connect the power plug to an easily reachable electrical outlet so that in case of an emergency the appliance can be unplugged immediately.

    • Once the appliance is connected to the electrical outlet, it emits a beep sound and enters standby mode.

  • Pull the power plug out of the electrical outlet to completely switch off the appliance.