Top > INSTALLATION > Installation > Dimensions and Clearances

Dimensions and Clearances

  • Make sure the appliance is placed horizontally to avoid grease collection at one end.

  • After installation, make sure that the power plug is accessible and can be pulled out if necessary.

  • The appliance should be placed 650-750 mm up from the highest point of the Cooktop's surface for safety and effective operation.

  • There must be adequate ventilation of the room when the appliance is working.

Model

HC7Z2425S

HC7Z3625S

A

598 mm

898 mm

Warning

  • The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.

  • Do not install the range hood near a heat producing appliance for solid fuel (e.g. wood or coal) unless a closed, nonremovable cover is available. There must be no flying sparks.

Wall Drilling and Bracket Fixing

  1. Power Socket

As a first step, proceed with the previous drawings:

  • Make sure that there are no electrical lines, water lines or other utilities in the drilling area before drilling.

  • A vertical line up to the ceiling or up to the upper limit, at the center of the area in which the range hood is to be fitted.

  • A horizontal line A at 1218 - 1718 mm above the cooker top.

  • A horizontal line B at a minimum 949 mm above the cooker top.

Mark points:

  • Mark a point (1) on the horizontal line A, 60 mm to the right of the vertical reference line.

  • Repeat this operation on the other side,checking that the two marks are leveled.

  • Mark a point (2) on the horizontal line B, 80 mm to the right of the vertical reference line.

  • Repeat this operation on the other side and on the vertical reference line, checking that the three marks are leveled.

Fix the wall plug:

  • Drill at the marked points (1) (2), using a Φ10 mm drill bit.

  • Insert the wall plugs into the holes (1) (2).

Choose the working mode

The range hood can be operated in recirculation or extraction-air mode. Extraction-air mode, the air is discharged out of the house by a pipe. Recirculation mode, the air is purified and discharged into the house through two rows of holes on the adjustable decorative chimney.

For recirculation mode, assembled activated charcoal filters on each side as cover to both the shield grids of the motor impeller, then turn clockwise a. For the disassembly, turn counter-clockwise b.

Note

  • For recirculation mode, without the exhaust pipe, install activated charcoal filters. When activated charcoal filters attached, the suction power will be lowered.