Unpacking the Appliance
Unpack the appliance and remove all packing tape and filter vinyl before using the appliance.
Hold the top of the rear cover of the product and pull it slightly to achieve separation.
‘PM1.0&GAS SENSOR SYSTEM’ is marked on the rear cover of the product.
Remove the packing support(a) from near the filter inlet.
Disassemble the filter and remove the vinyl.
Install the filter in the appliance.
Install it with the side where the handle(a) is attached facing up.
Insert the fixing part at the bottom of the cover into the fixing grooves at the bottom of the product and close the cover.
In case of the dual model, remove the support and the vinyl of the filter at the bottom of the air purifier in the same way.
Be sure to remove the filter packing support and the vinyl before using the product. Failure to do so may cause product malfunction.
Pay attention to filter direction when installing it. Failure to do so may cause product malfunction and failure.