Do not modify this appliance.

This appliance must be installed by an authorised technician or installer.

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible.

The adjustment conditions for this appliance are stated on the label (or data plate).

This appliance is not connected to a combustion products evacuation device. It should be installed and connected in accordance with current installation regulations. Particular attention should be given to the relevant requirements regarding ventilaton.

The device shall not be operated for more than 15 seconds. If after 15 seconds the burner has not lit, stop operating the device and open the compartment door and/or wait at least 1 minute before attempting a further ignition of the burner.

Before installing, turn off the gas and electricity supply to the appliance.

All appliances containing any electrical components must be earthed.

Ensure that the gas pipe and electrical cable are installed in such a way that they do not touch any parts of the appliacne which may become hot.

Gas pipe or connector should not be bent or blocked by any other appliances.

Check the dimensions of the appliance as well as the dimensions of the gap to be cut in the kitchen unit.

The panels located above the work surface, directly next to the appliance, must be made of nonflammable material. Both the stratified surfacing and the glue used to secure it should be heat resistant to prevent deterioration.

Turn on appliance tap and light each burners. Check for a clear blue flame without yellow tipping.

If burners show any abnormalties, check the following :

• Burner lid positioned correctly

• Flame spreader positioned correctly

• Burner vertically aligned with injector nipple

A full operational test and a test for possible leakages must be carried out by the technician after installation.

The fiexible hose shall be fitted in such a way that it cannot come into contact with a moveable part of the housing unit and does not pass through any space susceptible of becoming congested.