Dimensions and Clearances

This appliance is to be built into a kitchen unit or 600 mm worktop, providing the following minimum distances are allowed;

• The edges of the hob must be a minimum distance of 60 mm from a side or rear wall.

• 700 mm between the highest point of the hob surface including the burners and the underside of any horizontal surface directly above it.

• 400 mm between the hob surfaces, providing that the underside of the horizontal surface is in line with the outer edge of the hob. If the underside of the horizontal surface is lower than 400 mm, then it must be at least 50 mm away from the outer edges of the hob.

• There should be 50 mm clearance around the appliance.

• There should be 50 mm clearance between the hob surface and any combustible materials.

• If the installation surface is narrow, install the heatproof plate on the right, left and back.

• It is necessary to be built into kitchen furniture as indicated below. Clearances are required when fitting the hob with a cooker hood above.

  

• You must have a gap of at least 25 mm and at most 74 mm between the underneath of the appliance and any surface that is below it.

  • An oven must have forced ventilation to install a hob above it.

  • Check the dimensions of the oven in the installation manual.

  • The cut out size must obey the indication.