Installing the Appliance
Sponge
Remove the pan supports, the burner lid and flame spreader and carefully turn the appliance upside down and place it on a cushioned mat. Take care that the Ignition devices and flame supervision devices are not damaged in this operation.
Attach the sponge provided around the edge of the appliance.
Do not leave a gap in the sealing agent or overlap the thickness.
The thickness of the sponge material is 3 mm. The width of the sponge material is 10 mm. Attach the sponge around the edge of the hole in the worktop.
Do not use a silicon sealant to seal the appliance against the aperture. This will make it difficult to remove the appliance from the aperture in future, particularly if it needs to be serviced.
Make sure to install the stabilizing brackets to prevent tipping of the appliance.
Place the bracket b over the holes that match the size of the screws. There are one set of screw holes in each corner of the hob. Slightly tighten a screw c through the bracket b so that the bracket is attached to the hob. Adjust the position.
Carefully turn the hob back over and then gently lower it into the hole that you have cut out.
On the underneath of the hob, adjust the brackets into a position that is suitable for your worktop. Then fully tighten the screws to secure the hob into position.
d Screw Position