Gas Connection on the Appliance

The gas connection is located at the rear right of the appliance.

Only use connecting lines or flexible hoses (tubes) which comply with the applicable regulations and which are approved for this purpose.

Gas supply replacement and installation guidelines:

• Screw the female threaded elbow and the seal to the end of the gas pipe.

• Hold the elbow with a wrench and connect the flexible gas connecting tube (hose) to the elbow.

LNG

LPG

a Gas Pipe b Seal

c G1/2" female threaded elbow (suitable for 24 mm wrench)

d Ø11.5 female threaded elbow (suitable for 24 mm wrench)

1. Elbow

2. Black nut of manifold

3. Torque: 9±1 Nm

Adjusting the Direction of Elbow

1. The hexagonal head of the elbow

2. Tighten with a torque wrench of 9±1 Nm

3. The black bolt of the gas inlet pipe assembly

4. Hold still

After loosening the elbow, adjust the elbow interface to the required direction as required, and keep the hexagonal head of the elbow motionless with a wrench. Use a 9±1 Nm torque wrench to tighten the black bolt of the gas inlet pipe assembly. Ensure that the torque of the wrench is within the required range to prevent elbow breakage or damage caused by excessive force.

After the installation is tightened, check whether the parts are in good condition and test the air tightness to ensure the tightness of the installation. The installer is responsible for the results of the process.

Installing the Gas Hob

• Do not use too much force when tightening; Otherwise, it will cause elbow fracture or rubber ring deformation and leakage.

• Note that the torque wrench must be used to tighten with a torque of 10 Nm. The maximum torque cannot exceed 20 Nm.

The gas connection must be located in position where the stop tap is accessible. The end of the inlet connection point of the gas hob has a 1/2" thread that allows for:

• A fixed connection

• Connection using a flexible pipe

The seal supplied must be inserted between the manifold outlet and the gas supply. You must prevent the pipe from coming into contact with moving parts of the kitchen unit (for example, a drawer) and prevent access to any spaces which might become obstructed.

If there is no digital torque wrench, it is also allowed to use a wrench with a length of less than 200 mm (within 8 inches) for tightening. When tightening, care should be taken to avoid overtightening, and the airtightness must be checked after installation;

Flexible hose

If you use flexible hoses, make sure that:

• The hoses must not become trapped or squashed.

• The hoses must not be subject to twisting or pulling forces.

• The hoses must not come into contact with sharp edges or cutting edges.

• The hoses must not go behind the gas hob or close to the hot air exits.

• The hoses must come into contact with parts that could reach a temperature higher than 70 ℃, above room temperature. The hoses should be fine under these conditions.

• The flexible hose (tube) shall be fitted in such a way that it cannot come into contact with a moveable part of the housing unit (e.g. a drawer) and does not pass through any space susceptible of becoming congested.

• After the installation, check if there is any gas leak, using soap or liquid detergent foam.

Ensure that the full length of the hoses are accessible for inspection.