Wiping the Moisture Sensor

This device senses the moisture level of the clothes during operation, which means it must be cleaned once every six months to remove any build-up of lime scale on the surface of the sensor.Wipe the sensors inside the drum.Do not wipe the moisture sensor with abrasive materials. Always clean the sensor with a dry rough acrylic sponge.

Using Drum Clean Feature

With time and use, the appliance may form unpleasant odours that leave your clothes smelling after drying. Using this cleaning function once a month (or after drying 30 times) This helps to reduce the unpleasant odours from the appliance. Never use solvent or acidic based cleaners to wipe the inside of the drum. This can cause the drum finish to deteriorate or rust.Remove all of the clothes from the appliance.Pull out the water container, empty the condensed water from it and refit the water container back into the appliance.Turn on the appliance.Press the Drum Care button.Press the Start/Pause button.This function operates for about 3 hours.Empty the water container after the function has finished.When the optional drain hose is installed, there is no need to empty the water container.Open the dryer's door to provide the appliance with enough air circulation for exhausting any remaining odours.For safety reasons, do not allow children or animals to enter the appliance. It may cause damage or injury.

Cleaning the Condenser

This model has “Auto Condenser Cleaning”. But, if you want to clean it manually at your discretion, you can. Please follow the instructions below. Refer to the following instructions for manually cleaning the condenser.To avoid physical injury and burns, do not touch or clean the condenser with bare hands. Do not apply any liquids when manually cleaning the condenser. It is a dry cleaning method only.When cleaning the condenser, be careful not to damage the fins.If drying performance deteriorates, open the condenser cover to check for foreign substances or lint build up.Press the top part of the access panel a to open it.Turn the locks b to release the condenser cover, and pull the cover to remove it.Clean the dust on the condenser using a vacuum cleaner or soft brush. Do not apply force to the fins as they will bend which will affect the drying performance.Fit the cover with the hole below.Reinsert and reassemble the condenser cover completely.If the condenser cover is not completely reassembled, the product will not work properly and may leak.Close the access panel.

Using Condenser Clean Feature

The appliance washes lint, which builds up onto the surface of the condenser, by automatically using water that is condensed from the clothes during operation. Using this cleaning function once a month (or after drying 30 times) helps to wash the lint and maintain optimum drying performance.Remove all of the clothes from the appliance.Pull out the water container and empty the water container.Pour a 1 litre maximum of clean water slowly into the opening of the water container compartment.Then refit the empty water container into the compartment.Do not pour the water quickly as it will spill out.Pouring more that 1.0 litres of water into the compartment will cause water to leak back out.Turn on the appliance.Press and hold the Condenser Care button for 3 seconds.Press the Start/Pause button to start the cleaning of the condenser.The cleaning of the condenser proceeds for 1 hour.Empty the water container after the cleaning is finished.When the optional drain hose is installed, there is no need to empty the water container.Open the dryer's door to provide the appliance with enough air circulation for more thorough drying of the tub after the cleaning has ended.For safety reasons, do not allow children or animals to enter the appliance. It may cause damage or injury.