Stacking Kit Installation
The weight of the appliance and the height of installation make this stacking procedure too risky for one person. Two or more people are required when installing the stacking kit.
Place the washer on a solid, stable, level floor capable of supporting the weight of both appliances.
Do not stack the washer on top of the dryer.
If appliances are already installed, disconnect them from all power, water and drain connections.
- This stacking kit includes:
Two (2) side rails
One (1) front rail
Four (4) screws
To ensure safe and secure installation, please observe the following instructions.
Make sure the surface of the washer is clean and dry. Remove paper backing from the tape on one of the stacking kit side brackets.
Fit the side bracket to the side of the washer top as shown. Firmly press the adhesive area of the bracket to the washer surface. Secure the side bracket to the washer with a screw on the back side of the bracket. Repeat steps 1 and 2 to attach the other side bracket.
Place the appliance on top of the washer, fitting the dryer feet into the side brackets as illustrated. Avoid finger injuries; do not allow fingers to be pinched between the washer and the appliance. Slowly slide the appliance toward the back of the washer until the side bracket stoppers catch the dryer feet.
Insert the front rail between the bottom of the appliance and the top of the washer. Push the front rail toward the back of the washer until it comes in contact with the side rail stoppers. Install the two remaining screws to secure the front rail to the side rails.
