Testing the Dishwasher

Check if the dishwasher is properly installed.

• Turn on the circuit breaker.

• Turn on the house water supply.

• Make sure that the door opens and closes smoothly.

  • If necessary, level the dishwasher again.

  • If the door will not close, make sure the rack is level.

    

  • Make sure that all packaging materials have been removed.

    

• Power on the dishwasher and run a Turbo cycle to verify proper operation.

• Check for leaks at the drain hose and water supply connection.

• If a water leak is detected, press and hold the START button for 3 seconds to cancel the wash cycle and automatically drain the water from the dishwasher. Tighten all water connections and run another cycle. Repeat until no leaks are detected.

• Replace the lower cover.

  Caution

  • Only install the lower cover provided with the dishwasher. Do not install cabinet baseboard a as it may cause noise and leakage.

    

• Remove the protective film from the door, if present. Leaving the film on may cause discoloration or condensation on the door.