Storing the Washer

If the washer will not be used for an extended period of time and is in an area that could be exposed to freezing temperatures,follow these steps to protect the washer from damage.Make sure the tub is empty before following these steps.Turn off the washer, and unplug the power cord.Turn off the water faucets.Disconnect hoses from water supply and drain water from hoses.Plug the power cord into a properly grounded electrical outlet.Add 1 gallon of nontoxic recreational vehicle (RV) antifreeze to the empty tub and close the lid.Never use automotive antifreeze.Press the Special Use button to select the Spin Only cycle.Press the Start/Pause button to start the drain pump for 1 minute.This will expel some of the antifreeze, leaving enough to protect the washer from damage.Turn off the washer and unplug the power cord.Dry the tub interior with a soft cloth, and close the lid.Store the washer in an upright position.Remove the inserts from the dispenser. Drain any water in the compartments and let them dry.To remove the antifreeze from the washer after storage, run a Speed Wash cycle using detergent.Do not add laundry to this cycle.

When the Water Inlet Hoses are Frozen

Turn off the washer and unplug the power cord.Turn off the faucets connected to the water inlet hoses.Pour hot water on the frozen faucets to thaw the water inlet hoses and remove the water inlet hoses.Immerse the water inlet hoses in hot water to thaw them.Reconnect the water inlet hoses to the water inlets of the washer and to the faucets.See Connecting the Water Inlet Hoses for details.Turn on the faucets.Press the Power button to turn on the washer.Press the Special Use button to select the Spin Only option for draining and spinning.Press the Start/Pause button and check that the water fills properly.

When the Drain Hose is Frozen

Pour hot water in the washer tub and close the lid.Wait for 1 - 2 hours.Press the Power button to turn on the washer.Press the Special Use button to select the Spin Only option for draining and spinning.Press the Start/Pause button to make sure the water drains.