Cleaning the Wide Slim Hard Floor Nozzle

• Press the nozzle release button a to remove the nozzle from the extension pipe or product body.

  

• Turn the nozzle upside down and remove the rotating brush while holding down the PUSH button on the nozzle.

  

  Note

  • When removing the rotating brush from the nozzle, part of the edge of the rotating brush may detach. Reassemble the rotating brush by holding the rotating brush and the detached part of the edge and pushing them in until a click is heard.

    

• Attach the crevice tool to the product body and use the vacuum to remove foreign objects and dust from the brush and the bottom of the nozzle.

  

• Use a damp towel or cloth to remove any remaining foreign objects and dust from the brush and the bottom of the nozzle.

  • Do not wash the rotating brush and the nozzle with water or immerse them in water.

  • Use a wet towel or cloth and to clean the rotating brush and nozzle.

  

• Remove foreign objects, debris and hair from all Rollers of the nozzles using tweezers.

  

• You can clean the inside of the small roller by inserting a flat-head screwdriver into the groove and removing the fixing part.

  

• Reassemble the small roller and the fixing part and make sure that they are properly attached.

  

• When holding both ends of the rotating brush and pulling it out, the rotating brush and part of the edge will separate. If hair is wrapped around the edge of the rotating brush, remove the rotating brush and clean it.

  

• Reassemble the rotating brush and the part of the edge and insert the end of the rotating brush into the groove at the end of the nozzle.

  

• Slide the brush back into the nozzle until it clicks into place.