Flooring
To minimize noise and vibration, install the washer on a level, solidly constructed floor capable of supporting the washer without flexing or bouncing.
The washer must be installed on firm flooring to minimize vibration during the spin cycle. Concrete flooring is best, but a wood floor is sufficient, provided it is built to FHA standards.
The floor under the washer must not slope more than 1 inch (2.5 cm) from front to back or side to side.
Installing on carpeting and soft tile surfaces is not recommended.
Never install the washer on a platform or weakly supported structure.
- Floor Installation
To ensure sufficient clearance for water inlet hoses, drain hose and airflow, allow minimum clearances of at least 1 inch (2.5 cm) at the sides and 4 inches (10 cm) behind the washer. Be sure to allow for wall, door, or floor moldings that may increase the required clearances.
Minimum vertical space from floor to overhead shelves, cabinets, ceilings, etc., is 56 inches.
Dimensions and Clearances | |
|---|---|
A | 1” (2.5 cm) |
B | 27” (68.6 cm) |
C | 45 5/8” (115.9 cm) |
D | 56” (142.3 cm) |
E | 26 3/4” (68 cm) |
F | 3 1/2” (9 cm) |
G | 32” (81.1 cm) |
H | 28 3/8” (72.1 cm) |