Top > INSTALLATION > Connecting the Drain Hose

Connecting the Drain Hose

If the end of the drain hose does not fit the drain line, use a heat and detergent resistant adapter (not supplied). These may be obtained from a local plumbing supply store.

  • Cut the adapter to match the size of the drain connection as shown. Cutting just beyond the flare helps to keep the band clamp in place.

Note

  • For drain hose installation, use the screw style hose clamp provided with this dishwasher in the silverware basket.

  • If connecting the dishwasher’s drain hose to the garbage disposal, be sure to follow your garbage disposal’s manual for proper installation instructions.

Contains Topics

Drain Hose Requirements

Follow local codes and ordinances.Do not exceed 12 ft. (3.65 m) distance to drain.Do not connect drain hoses from other appliances to the dishwasher’s drain hose.If an extension drain hose is required, use a 5/8" or 7/8" inside diameter, 2-3 ft. length hose and a coupler a for connecting the two hose ends.The height of the drain hose end must be at least 12" (305 mm) and within 40" (1016 mm) from the base of the dishwasher to avoid water being siphoned from the tub.

Connecting to Disposal without Air Gap

Remove the knockout plug on the disposal with a hammer and screwdriver. Remove the knockout plug a from the disposal.If the knockout plug has not been removed, the dishwasher will not be able to drain properly.Attach the drain hose to the disposal with the hose clamp provided. Move the hose clamp into position and tighten it with a flat-blade screwdriver.

Connecting Waste Tee without Air Gap

The height of the drain hose end must be at least 12” (305 mm) and within 40” (1016 mm) from the base of the dishwasher to avoid water being siphoned from the tub.Remove the knockout plug with a hammer and screwdriver.If the knockout plug has not been removed, the dishwasher will not be able to drain properly.Attach the drain hose to the waste tee with the hose clamp provided. Move the clamp into position and tighten it with a flat-blade screwdriver.

Connecting to Disposal or Waste Tee with Air Gap

Remove the knockout plug with a hammer and screwdriver.Connect the end of the drain hose a to the air gap b with the hose clamp provided. Move the clamp into position and tighten it with a flat-blade screwdriver.This avoids water being siphoned from the tub.If it is not connected, attach the rubber hose connector to the disposal or waste tee with a hose clamp (not provided).