Testing the Dishwasher

Check if the dishwasher is properly installed.Turn on the circuit breaker.Turn on the house water supply.Make sure that the door opens and closes smoothly.If necessary, level the dishwasher again. If the door will not close, make sure the rack is level.Make sure that all packaging materials have been removed.Power on the dishwasher and run a Turbo cycle to verify proper operation.Check for leaks at the drain hose and water supply connection.If a water leak is detected, press and hold the START button for 3 seconds to cancel the wash cycle and automatically drain the water from the dishwasher. Tighten all water connections and run another cycle. Repeat until no leaks are detected.Replace the lower cover.Only install the lower cover provided with the dishwasher. Do not install cabinet baseboard a as it may cause noise and leakage.Remove the protective film from the door, if present. Leaving the film on may cause discoloration or condensation on the door.

Installation Check Error Codes

Refer to the chart below before calling for service.Error CodePossible Cause and SolutionOEDrain hose is kinked or pinched.Feed the drain and water supply hoses through the hole under the sink. Then gradually slide the dishwasher into the cabinet while pulling on the hoses under the sink to take up any slack. This helps avoid kinking the hoses or trapping them beneath the dishwasher.Drain hose is connected to the disposal without removing the knockout plug.Remove the knockout plug from the disposal.Waste tee or disposal is clogged.Remove knockout plug on the waste tee or disposal.IEWater supply line is kinked under dishwasher.Feed the drain and water supply hoses through the hole under the sink. Then gradually slide the dishwasher into the cabinet while pulling on the hoses under the sink to take up any slack. This helps avoid kinking the hoses or trapping them beneath the dishwasher.House water supply is not turned on.Turn the water faucet on.