Leveling

The refrigerator has two front leveling legs. Adjust the legs to alter the tilt from front-to-back or side-to side. If the refrigerator seems unsteady, or the doors do not close easily, adjust the refrigerator’s tilt using the instructions below.Turn the leveling leg to the left to raise that side of the refrigerator or to the right to lower it. It may take several turns of the leveling leg to adjust the tilt of the refrigerator.A flare nut wrench works best, but an open-end wrench will suffice. Do not over-tighten.Open both doors and check to make sure that they close easily. If the doors do not close easily, tilt the refrigerator slightly more to the rear by turning both leveling legs to the left. It may take several more turns, and be sure to turn both leveling legs the same amount.

Door Alignment

Both the left and right refrigerator doors can be raised and lowered by inserting or removing rings on the bottom hinges to ensure proper alignment.If the space between the doors is uneven, follow the instructions below to align the doors:Open the door and lift it from the bottom.Lift the 2-hole washer.Insert the snap ring to adjust the height.While the door is lifted, have an assistant insert the snap ring under the 2-hole washer. The snap ring may differ depending on the model.Snap ring type AUse pliers to insert the snap ring under the 2-hole washer of the inner door section as shown.Insert additional snap rings until both the left and right refrigerator doors are aligned.Snap ring type BInsert only one snap ring on the middle hinge of the inner door section as shown.If a snap ring is already inserted under the 2-hole washer, remove the snap ring before inserting a new snap ring.The door is heavy. To avoid injury, use two or more people to lift and align the refrigerator door.Small parts are a swallowing hazard for small children. Keep snap rings out of the reach of children.On door-in-door models, insert the snap ring on the hinge of the INNER door section.The number of freezer drawers may vary depending on the model.