Use of Tripod - LG xboom Stage501 Portable Bluetooth Speaker
You can mount the product on a tripod. The tripod is an optional purchase.
|
|
|
> CAUTION
|
- • Extend the tripod legs as much as possible and tighten up the screw securely.
- • Before connecting with the product, you must set up the tripod completely to prevent shaking.
- • You should work together with two or more people when connecting the product and the tripod.
|
- a Unfold the tripod on a flat surface and then fix the tripod. Tighten up the tightening part of the tripod.
- b Open the tripod hole cup on the bottom of the product.
- c Lift the product and connect the tripod to fixing part on the bottom of the product.
|
|
|
 Note
|
- • If you use a tripod, use the tripod only for product.
- • Use tripod as below :
- - From tripod’s centre to tripod’s leg : above 700 mm
- - From top of tripod to bottom of tripod : below 1100 mm
- - Stand pole size : Φ 35 mm
- • For safe use, set the tripod as low as possible.
- • You should pull the centre column to the maximum only in case of need.
- • Mount only one product on each tripod.
- • Do not try to extent the tripod legs beyond it’s allowed range.
- • Make sure the tripod is correctly assembled and all its components are tightly connected.
- • Do not try to assemble the tripod if parts are missing or defective.
- • After installation, make sure the product is set up firmly on the tripod.
- • Do not place the product on anything unstable where it might accidentally fall over.
- • Add weight such as sand bags around the tripod legs to prevent the tripod from falling over.
- • You should limit people around the product while its on a tripod. Otherwise it may result in an accident and may cause personal injury or property damage.
- • Standing on the stool to reach product's control panel is risky and might lead to injuries.
- • Do not put or attach other objects on the tripod.
- • Do not shake or push the product when the tripod is installed.
- • Refrain from moving around the tripod after product is installed.
- • Remove all connected cables to the product on the tripod before moving the tripod or adjusting its height.
- • When transporting or moving the product, always use two or more people.
- • When you use the tripod, use an extension cord. Always be careful with the movement of the cable.
- • Do not expose the product to excessive dust, vibrations, extreme cold or heat (such as in direct sunlight or near a heater) to prevent the possible disfigurement of the panel or damage to the internal components.
- • When using the external input cable (Mic, etc.) after installing the product on the tripod, external input cable can cause the product to fall down.
- • Watch out because people can trip over the input cable (Mic, etc.) connected the product.
- • Always be careful not to trip over the product.
|