Filling with Dishwasher Salt
The salt dispenser must be filled with salt before starting the washing programme. In case of insufficient salt, the Salt Refill n icon indicates on the display, unless the hardness level has been set to H0.
Once you have filled with dishwasher salt you must run the Rinse cycle immediately to remove the salt and the salt water around the inner tub in order to prevent corrosion.
Remove the lower rack and remove the cap of the salt dispenser located on the left side of the filters.
Before using the appliance for the first time, it is necessary to pour 1 kg of dishwasher salt and 1 L of water at the same time if intending to use the water softener system. When refilling the salt, use a funnel. Refer to Before Using section.
Refit the cap tightly.
Run the Rinse cycle without dishes.
Salt Refill Cycle (1 kg for each load)
H1 | H2 | H3 | H4 | |
|---|---|---|---|---|
Cycles | 130 | 50 | 20 | 10 |
The table describes information of Auto programme.
Cycle may vary on the salt refill amount.
Do not pour any detergent in the salt dispenser. It will cause a malfunction.
Wipe off any spilled salt around the salt dispenser cap. Saline solution that runs into can cause corrosion in the tub and to the dishwasher load.
Seal the cap properly by aligning it horizontally and turning it clockwise. A loosely fitted cap may cause the saline solution to leak from the salt dispenser into the tub and cause corrosion.
After refilling the dishwasher salt, a wash programme should be operated without dishes, as any spilled salt inside the appliance may cause rust or damage to the appliance if the left unwashed.
