8. Adjusting the Surface Burner Low Flame (Simmer) Setting

• Light all surface burners.

• Turn the knob on the burner being adjusted to LO (LOW).

• Remove the knob.

• On dual burner knob rings only, remove the plastic cover a on the knob ring by turning it counterclockwise.

  

  CLOSE	OPEN

• For single-valve burners, insert a small, flat-blade screwdriver into the valve stem.

  For dual-valve burners, insert a small, flat-blade screwdriver into the hole to the left of the valve stem.

  

  1. Single Valve Adjustment Screw

  2. Dual Valve Adjustment Screw

• Turn the adjustment screw until the flame reaches the desired size.

• Replace the knob.

• Test the flame stability.

  Test 1

  • Turn the knob from HI to LOW quickly.

  • lf the flame goes out, increase the flame size and test again.

  Test 2

  • With the burner on a LOW setting, open and close the oven or cabinet door quickly.

  • If the flame is extinguished by the air currents created by the door movement, increase the flame height and test again.

• Repeat steps 1 - 6 for each surface burner.

• After setting the low flame, turn off the burner.