Assembling the Left Refrigerator Door

• Make sure that the plastic sleeve is inserted in the bottom of the door. Install the refrigerator door onto the middle hinge.

  

• Fit the hinge a over the hinge lever latch b and slot it into place. Rotate the lever c clockwise and fasten the hinge.

  

• Connect all the wire harnesses and the ground wire.

  

  Note

  • The number of wire harnesses may vary depending on the model.

• Push the water supply tube into the hole on the top case and pull it through the backplate.

  

• Hold the water supply connection and gently push in the collet d to connect the water supply line as shown. Insert the tube at least 5/8 inch (15 mm) into the connector. Insert the clip on the joint to fasten the tube in place.

  

  Note

  • Disassembling/Assembling the Water Lines

    

    e Collet f Tube g Insert line h Clip

  • Gently press the collet and insert the tube until only one line shows on the tube.

    

• Place the cover i in place. Insert and tighten the cover screw j.