Tip Hazard

Warning

CAUTION, POSSIBILITY OF TILTING

ANTI-TIP RESTRAINTS

• A child or adult can tip the range and be killed.

• Install the anti-tip device to the structure and/or the range. Verify the anti-tip device has been properly installed and engaged by following the guide on the anti-tip bracket template.

• Engage the range to the anti-tip device by following the guide on the anti-tip bracket template. Ensure the anti-tip device is re-engaged when the range is moved by following the guide on the anti-tip bracket template.

• Re-engage the anti-tip device if the range is moved. Do not operate the range without the anti-tip device in place and engaged.

• See installation instructions for details.

• Failure to follow these instructions can result in death or serious burns to children or adults.

• Range must be secured with an approved anti-tip device.

• The range could be tipped by standing, sitting or leaning on an open door if the range or anti-tip device is not properly installed.

• The use of this device does not preclude tipping of the range when not properly installed.

• After installing the anti-tip device, verify that it is in place by carefully attempting to tilt the range forward.

• This range has been designed to meet all recognized industry tip standards for all normal conditions.

• The installation of the anti-tip device must meet all local codes for securing the appliance.

Engaging the Anti-tip Device

The range is supplied with anti-tipping chains to prevent the appliance from tilting forward or causing accidental damage to the gas pipe.

To install the anti-tip device, follow the steps below:

• If the anti-tip device is to be mounted to drywall, use a drill with an 8 mm (5/16”) drill bit to drill two holes as shown.

  

  1. Hole

• Insert the wall anchors into the holes and screw in the hooks until they are firmly fixed to the wall, with the opening facing up.

  

  1. Hole

  2. Anchor

  3. Hook

• Use a screwdriver to remove the screws shown below from the rear of the range.

  

  1. Screw

• Insert the link on the end of one chain over the shank of a screw, insert the screw back in the rear of the range, and tighten it to firmly hold the chain in place. Repeat on the other side.

  

  1. Chain

  Note

  • Before moving the range into the enclosure, loop a string through the free end of the chain and tape the ends of the string to the top of the range. Repeat with the chain on the other side.

• Slide the range partially into place in the enclosure, leaving enough space behind it to reach the hooks. Use the string loops to grab the end of each chain. Attach the end of the chain to the hook and slide a transparent sheath over the end of the hook.

  

  1. Wall

  2. Transparent sheath

  3. Anchor

  4. Hook

  5. Chain