Top > INSTALLATION > Connecting the Water Inlet Hoses > Connecting the Hose to the Water Tap

Connecting the Hose to the Water Tap

  • Unscrew the adapter ring plate a and loose the 4 fixing screws.

  • Remove the guide plate b if the tap is too large to fit the adapter.

  • Push the adapter onto the end of the tap so that the rubber seal is connected to be watertight. Tighten the 4 fixing screws and the adapter ring plate.

  • Pull the connector latch plate c down, push the inlet hose onto the adapter, and release the connector latch plate. Make sure the adapter locks into place.

Note

  • After connecting the water inlet hose to the water tap, turn on the water tap to flush out foreign substances (dirt, sand, sawdust, and etc.) in the water lines. Let the water drain into a bucket, and check the water temperature.