Before Installing the Hob

• Make sure that the work surface is square and level, and no structural members interfere with space requirements. An uneven surface can cause the hob glass to crack unexpectedly due to unequal surface pressures.

• Make sure that the work surface is made of a heat-resistant and insulated material.

• If the hob is installed above an oven, the oven must have a built-in cooling fan.

• The installation must comply with all clearance requirements and applicable standards and regulations.

• Make sure that a suitable isolating switch providing full disconnection from the mains power supply is incorporated in the permanent wiring, mounted and positioned to comply with local wiring rules and regulations.

• A device must be provided in the electrical installation that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors.

• The isolating switch must be easily accessible to the customer with the hob installed.

• Consult local building authorities and by-laws if in doubt regarding installation.

• Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding the hob.

• The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN 68930.

After Installing the Hob

• Maker sure that the power cord is not accessible through cupboard doors or drawers.

• Make sure that there is adequate flow of fresh air from outside the cabinetry to the base of the hob.

• If the hob is installed above a drawer or cupboard space, a thermal protection barrier must be installed below the base of the hob.

• The isolating switch must be easily accessible by the customer.

Before Locating the Fixing Brackets

• The appliance should be placed on a stable, smooth surface. Do not apply force onto the buttons protruding from the hob.

Adjusting the Bracket Position

Fix the hob on the work surface by screwing 2 brackets on the bottom of hob(see picture) after installation. Adjust the bracket position to suit the particular work top thickness.

Connecting the hob to the mains power supply

This hob must be connected to the mains power supply only by a qualified electrician.

Before connecting the hob to the mains power supply, it is the Electricians responsibility to check that:

• The domestic wiring system is suitable for the power drawn by the hob.

• The voltage corresponds to the value given in the rating plate.

• The power supply cable sections can withstand the load specified on the rating plate.

Connect the hob to the mains power supply. Do not use adapters, reducers, or branching devices, as they can cause overheating and fire.

The power supply cable must not touch any hot parts and must be positioned so that its temperature will not exceed 75 ℃ at any point.

Check with an electrician whether the domestic wiring system is suitable without alterations.

Any alterations must only be made by a qualified electrician.

1. Yellow / Green

2. Blue

3. Brown

4. Black

If the total number of heating units of the appliance you choose is not less than 4, the appliance can be connected directly to the mains by single-phase electric connection, as shown below.

1. Yellow / Green

2. Blue

3. Brown

4. Black

• If the power cord is damaged or needs to be replaced, contact an LG Electronics Customer Information Centre.

• The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations.

• If the appliance is being connected directly to the mains an omnipolar circuit-breaker must be installed with a minimum opening of 3 mm between contacts.

• The power cord must not be bent or compressed.

• The power cord must be checked regularly and replaced by authorised technicians only.

• Once the hob is connected to the mains supply, check that all cooking zones are ready for use by briefly switching each on in turn at the maximum setting with suitable cookware.