Top > INSTALLATION > Removing/Assembling Doors and Drawers > Assembling the Left Refrigerator Door

Assembling the Left Refrigerator Door

Caution
  • Install the left refrigerator door after the right door is installed.

  • Make sure that the plastic sleeve is inserted in the bottom of the door. Install the refrigerator door onto the middle hinge.

  • Fit the hinge a over the hinge lever latch b and slot it into place. Rotate the lever c clockwise and fasten the hinge.

  • Connect all the wire harnesses and the ground wire.

  • Push the water supply lines into the hole on the top case and pull them through the backplate.

  • Hold the water supply connection and gently push in the collet d to connect the water supply lines as shown. Insert the tube at least 5/8 inch (15 mm) into the connector. Insert the clip on the joint to fasten the tubes in place.

    Note
    • Disassembling/Assembling the Water Lines

      e Collet f Tube g Insert line h Clip

    • Gently press the collet and insert the tube until only one line shows on the tube.