Do not attempt to open or close the door or operate the oven until the door is properly installed.
Have the installer show you the location of the range gas shut-off valve and how to shut it off if necessary.
To shut off the gas supply to the range, close the range gas shut-off valve by turning it.
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible.
The adjustment conditions for this appliance are stated on the label.
This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.
Make sure your range is properly installed and grounded by a qualified installer, according to the installation instructions. Any adjustment and service should be performed only by qualified gas range installers or service technicians.
Make sure your range is properly adjusted by a qualified service technician or installer for the type of gas (natural or LP) that is to be used. Your range can be converted for use with either type of gas. See the installation instructions.
These adjustments must be done by a qualified service technician according to the manufacturer’s instructions and all codes and requirements of the authority having jurisdiction. Failure to follow these instructions could result in serious injury or property damage. The qualified agency performing these adjustments assumes responsibility for the conversion.
Disconnect the electrical supply before servicing the appliance.
This product should not be installed below ventilation type hood systems that direct air in a downward direction.
Doing so may cause ignition and combustion problems with the gas burners resulting in personal injury and may affect the cooking performance of the unit.
To prevent poor air circulation, place the range out of the kitchen traffic path and out of drafty locations.
This gas appliance must be installed only by qualified personnel.
Before installation, make sure that the conditions of local distribution (nature and pressure of the gas) and the adjustment of the gas appliance are compatible.
The adjustment conditions can be found on the label (or plate of data).
If it is designed to be connected to an evacuation device of the products of combustion. Must be installed and connected in accordance with current installation requirements. Should be given pay particular attention to the relevant ventilation requirements.
For its correct operation, this gas appliance needs to be adjusted according to local pressure conditions atmospheric and room temperature.