Top > MAINTENANCE > Cleaning the Appliance > Cleaning the Dust Bin

Cleaning the Dust Bin

Empty and clean the dust bin after every use.

  • If the dust bin is completely full of dust or the filter is clogged, the suction power may be reduced.

Caution
  • Do not use the appliance without the dust bin filter installed. Doing so could damage the appliance.

  • Remove the battery from the product body before cleaning the dust bin.

  • Push down the Kompressor lever a several times to collect and compact the dust from the outside of the dust bin filter and the interior walls of the dust bin.

    • Foreign objects which become lodged in the dust bin filter may be difficult to dislodge with the Kompressor lever. Remove the dust bin filter and use a soft brush to clean it.

  • Press the dust bin cover release button b to open the dust bin cover. Shake the dust bin to empty it.

    • Be careful as dust or foreign objects may spill out when opening the dust bin. Empty the dust bin into a wastebasket or where dust and foreign objects can be easily removed.

    • The dust bin can be wrapped in a plastic bag to contain the dust when emptying the dust bin.

    Warning
    • If the Kompressor lever does not slide down smoothly, foreign objects may be trapped between the dust bin and the dust bin filter. Clean the dust bin and dust bin filter to avoid product damage.

    • Do not force the Kompressor lever down if foreign objects are caught around the working plate of the Kompressor system. Doing so may cause product damage. Never hit the main body of the unit or its filters against a hard surface to remove debris or blockages. Doing so can damage the unit.

  • Insert the crevice tool d into the dust bin filter c and turn it counterclockwise to remove the filter.

  • Remove the Micro Filter from the Dust bin Filter.

    • When separating the Dust bin Filter, the Micro Filter is separated in an assembled state. If it was not separated together with the Dust bin Filter, check the inside of the vacuum cleaner and take out the Micro Filter.

  • Grab the dustbin and turn it to the left to separate the dustbin.

  • Remove dust from the dust bin, dust bin filter, and micro filter using a cleaning brush, etc., and wash them with water at least once a month.

    • If any stains remain, soak in lukewarm water (about 40 degrees) for 30 minutes and then wash with a brush.

    • To avoid odor and the malfunction of the motor, allow the Dust bin Filter to dry completely in a well-ventilated area out of direct sunlight for at least 24 hours before reassembling.

  • Use the combination tool e to clean out dust or foreign objects inside the dust bin.

    • Do not wash the product body or motor with water.

  • Turn the product body over again and shake it while pressing down the lever to remove the dust.

  • Turn the product body over, lift the Kompressor lever up, and clean the inside of the working plate with a damp paper towel.

    • Do not push the Kompressor lever down hard. The working plate may be damaged.