Top > OPERATION > Control Panel and Remote Control > Overviews

Overviews

Control Panel

Remote Control

Note

  • Features may change depending on the model type.

  1. POWER

    Press to turn the air conditioner ON or OFF.

  2. FAN SPEED

    Press to set the fan speed to LOW (F1), MED (F2) or HIGH (F3).

  3. TIMER (Delay ON/OFF Timer)

    • Delay ON

      When the air conditioner is off, set it to automatically turn on from 1 to 24 hours later, at its previous mode and fan settings.

    • Delay OFF

      When the air conditioner is on, set it to automatically turn off from 1 to 24 hours later.

    Note

    • Each press of the TIMER button advances the timer by 1 hour. After the last press the display returns to the temperature setting.

  4. MODE (Operation Mode)

    Press the MODE button to cycle between 4 types of air conditioner operation: Energy Saver / COOL / FAN / DRY.

    • Energy Saver

      In this mode the compressor and fan turn off when the set temperature is achieved. Approximately every 3 minutes the fan turns on to allow the unit sensor to accurately determine if more cooling is needed.

    • Cool

      This mode is ideal on hot days to cool and dehumidify the room quickly. Use the TEMP J K buttons to set the desired room temperature and use the FAN SPEED button to set the desired fan circulation speed.

    • Fan

      In this mode the fan circulates air but the compressor does not run. Use the FAN SPEED button to set fan speed to HIGH, MED or LOW. In this mode, you cannot adjust the set temperature.

    • Dry

      This mode is ideal for rainy and damp days to dehumidify the room rather than cooling it significantly. Humidity is reduced from the room by the combination of compressor operation and the fan speed fixed at LOW. The compressor and fan turn off once the set temperature is reached. Fan speed cannot be adjusted in Dry mode.

  5. TEMP (Temperature Control)

    The thermostat monitors room temperature to maintain the desired temperature. The thermostat can be set between 60 ℉ – 86 ℉ (16 ℃ – 30 ℃). Press J or K arrows to increase or decrease the temperature setting.

Note

  • Auto Restart : If the air conditioner turns off due to a power outage, it will restart automatically once the power is restored, with the same settings as were set before the unit turned off.

  • Energy Saver : The unit defaults to the Energy Saver mode each time the unit is switched on except in Fan mode or when power is restored after an electrical power outage.

  • The remote control will not function properly if the AC infrared sensor is exposed to direct light or if there are obstacles between the remote controller and the air conditioner.