If the appliance is not used for a long period, dispense the stored water from water purifier tank. If water has been left for a long period, bacteria can be generated and water taste can be changed.
When you fill the cup with water, place it close to the water tap. Water may splash out of the cup and fall to the floor.
Open the water supply valve. The appliance operates normally when water is supplied properly at a consistent pressure that is within the operating requirement.
It is very important to replace the filter periodically in order to drink clean water. If an expired filter is used, the water taste may be changed and the filtration function may be degraded.
Do not use filtered water to replace water in a humidifier or fishbowl. Leaving filtered water as it is for a long period of time may multiply the bacteria.
Use the appliance only after closing the appliance cover completely. Otherwise, insects or other foreign substances may get in.
When the water supply is cut off or the water pressure is low, the purifier's performance may decline. Check the original water pressure.
The RO (Reverse Osmosis) contains a replaceable treatment component critical for the effective reduction of TDS (Total Dissolved Solids) and that product water shall be tested periodically to verify that the system is performing properly.
Do not use with water that is microbiologically unsafe or of unknown quality, without adequate disinfection before or after the system.
If the product will not be used for 2 or more days, unplug the power cord and close water supply valve before leaving premises and drain the water inside of water filtration system including tank completely before consumption of water.
All models of water purifier comes with a unique flow sensor which turns on only if there is running water supply to water purifier.
If no/lower water supply than specified limit is available, then water purifier will stop for 15 minutes and later, runs again for few seconds to check water supply.
If water supply is detected, then water purifier will work normally otherwise it will repeat to check cycle again.
If water supply is available and you want to start water purifier immediately, must turn off the power supply and wait until the display gets turned off, and turn on the power again.