Do not lean the appliance more than 30°. Doing so can cause malfunctions.
Keep a distance of 10 cm from front and sides of the product.
A cold water supply with water pressure between 0.01 MPa and 0.86 MPa (0.1-8.8 kgf/cm²) is required to operate this appliance.
If you do not use the appliance for a while due to moving, etc., store it in an environment where water does not freeze.
The appliance may malfunction due to freezing.
Install on a hard and level floor/wall.
If the floor/wall of the installation site is uneven, vibration or noise may occur, and the appliance may fall over and cause injury.
Places where installation should be avoided for hygienic management of water purifiers and prevention of condensation.
Outdoors or in direct sunlight
A place close to the toilet
In front of air conditioner/heater
Other places with high humidity or temperature
Height between immediate water reservoir tank to water purifier inlet should be more than 1 meter for effective working of the product.
For optimum performance of product, installation condition should be 1 2000 mg/L TDS, hardness 1 425 mg/L and turbidity 1 5 NTU.
All models can only be installed with water supply from overhead storage tank. No other water supply should be used for installation of these models.