Top > MAINTENANCE > Cleaning > Cleaning the Air Filter

Cleaning the Air Filter

Warning

  • Wear gloves during the work.

  • Before cleaning or performing maintenance, disconnect the power supply and wait until the fan stops.

Caution

  • When you remove the air filter, do not touch the metal parts of the indoor unit. Doing so may cause an injury.

  • Do not bend the air filter, as it may break.

  • Assemble the air filter properly to prevent dust and other substances from entering the product.

Removing the Filter

  • Press the Knobs a on both sides and open the front grille.

  • Press the Clips b on both sides and seperate the bottom of the air filter from the front grille.

  • Remove the air filter.

  • Press the Fixing Handle c and pull down the upper side of PM1.0 Filter d.

    Warning

    • Don't touch the PM1.0 Filter within 10 seconds after opening the front grille.

      • Unless, it may cause an electric shock.

  • Lift the PM1.0 Filter slightly and remove it from the appliance.

  • Remove the Deodorization Filter e by pressing it up.

Cleaning the Air Filter

  • Clean the air filter with a vacuum cleaner or wash it with lukewarm water and a mild detergent.

  • Dry the filter in the shade.

Cleaning the PM1.0 Filter and Deodorization Filter

PM1.0 Filter

  1. Soak the PM1.0 filter in enough water to submerge it and shake it several times to clean it.

    • Clean the filter without disassembling it.

    • If it is heavily soiled, soak it in lukewarm water with neutral detergent for 30 minutes, then rinse thoroughly with clean water.

  2. Dry in the shade for about a day.

    • If you assemble the PM1.0 filter with moisture remaining, 7 beeps will sound.

Caution

  • Do not use hot water over 40 \ or volatile liquids.

  • Do not use acidic detergents such as citric acid.

  • Drying with a hot air heater, such as a hair dryer or a heater, could damage or deform the filter.

  • The inside of the filter is sharp, so do not rub or touch it directly.

Deodorization Filter

Do not wash the deodorization filter with water and dry for about 3 hours under weak sunlight or fluorescent light.

  • Washing the filter with water could damage or deform it.

Mounting the Filter

  • Insert the Deodorization Filter e into the PM1.0 Filter by pressing it down.

  • Mount PM1.0 Filter d on the hooks.

  • Push up the upper side of PM1.0 Filter and fix to the appliance.

  • Insert the hooks on the upper side of the air filter into the holes.

  • Insert the clips into the hooking holes on the bottom of front grile.

  • Close up the front grille to the appliance.

  • Fix the upper side of the front grille by pressing the knobs.

  • Press the centre of the left and right sides once.