Top > OPERATION > Wireless Remote Control Overview > Wireless Remote Control

Wireless Remote Control

Use the wireless remote control to operate the appliance more conveniently.

Buttons

Image	Description
	PLASMA Supplies clean and fresh air by air purification filter Note This function is available only when the air purification filter is installed in the appliance.
	E/SAVING (Energy Saving Cooling) Adjusts the desired temperature during the cooling operation to enhance the comfort of the user and improve the energy saving performance
	A/CLEAN (Auto Clean) In Cooling and Dehumidification modes, moisture is generated inside the indoor unit. Use this function to reduce the moisture.
	On/Off Turns the appliance on/off
	Temperature Setting O, P Adjusts the desired temperature
	MODE Selects the desired operating mode Each press changes the modes in this order: Cooling ~ Auto ~ Dehumidification ~ Heating ~Fan.
	FAN SPEED Adjusts the fan speed
	JET COOL Changes the room temperature quickly
	SWING (Up-Down Swing) Adjust the airflow direction up and down Press once more Swing (Up-Down Swing) button during rotation, the wind direction is fixed at the desired location.
	HEATER Used to start or stop the Floor Heating mode.
	ROOM TEMP (Room Temperature) Displays the current room temperature
	SLEEP Operates the air conditioner in Sleep mode before turning it off automatically at the set time
	ON Reserves the time that the air conditioner is automatically turned on.
	OFF Reserves the time that the air conditioner is automatically turned off.
	Timer Setting m, n Adjusts the time on the display
	LIGHT Press the c button to turn the LED display on or off.
	SET/CLEAR Sets or cancels the special functions or timer
	TIME(3 s) Press and hold the Set/Clear button for about 3 seconds to set the current time on the wireless remote control.
	Reset Resets the wireless remote control setting

Icons

	Cooling Mode		Dehumidification Mode
	Heating Mode		Fan Mode
	Auto Mode		Up-Down Swing
	Heater		Sleep Timer
	Energy Saving Function		Room Temperature
	Desired Temperature		Adjusting the Fan Speed
	Air Purification		Auto Clean Function

Caution

Aim at the signal receiver on the wired remote controller so as to operate.
The remote control signal can be received at a distance of up to about 7 m.
Be sure that there are no obstructions between the remote controller and the signal receiver.
Do not drop or throw the remote controller.
Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or any other heat source.
Be sure to block the strong light over the signal receiver with a curtain or etc. so as to prevent the abnormal operation.
- Example) Electronic Quick Start, ELBA, Inverter Type Fluorescent Lamp

Note

Some products don’t receive the wired signals.
When using the simultaneous operation system, the system will operate approximately 1 - 2 minutes after pressing the remote controller button.
The displayed temperature can be different from the actual room temperature if the remote controller is installed somewhere exposed to direct sunlight or is nearby a heat source.
Depending on the product, wireless and wired remote control are optional or basic.
The wireless remote controller do not operate the swirl mode.