Assembling the Freezer Door

• Install the freezer door onto the bottom hinge pin a.

  

• Fit the hinge b over the hinge lever latch c and slot it into place. Rotate the lever d clockwise and fasten the hinge.

  

  Note

  • Align the freezer door with the cabinet to help fit the top hinge in place.

• Connect all the wire harnesses and the ground wire.

  

  Note

  • The number of wire harnesses may vary depending on the model.

  • Ground wire is only present on some models.

• Push the water supply lines into the hole on the top case and pull them through the backplate.

  

• Hold the water supply connection and gently push in the collet e to connect the water supply lines as shown. Insert the tube at least 5/8 inch (15 mm) into the connector. Insert the clip on the joint to fasten the tubes in place.

  

  Note

  • Disassembling/Assembling the Water Lines

    

    f Collet g Tube h Insert line i Clip

  • Gently press the collet and insert the tube until only one line shows on the tube.