Connecting the Hose to the Water Tap
Unscrew the adapter ring plate a and loosen the 4 screws at the end of the adapter.
If the tap is too large to fit the adapter, remove the guide plate.
If the tap is large, remove the inner guide plate c on the adapter and adjust the screws to leave the inside clear.
If the tap is still too large, remove the outer guide plate b and adjust the screws again.
Push the adapter onto the end of the tap so that the rubber seal makes good contact with the tap. Tighten the 4 fixing screws and the adapter ring plate.
Pull the connector latch plate d down, push the inlet hose onto the hose, and release the connector latch plate. Make sure the hose locks into place on the adapter.
Remove foreign substances (dirt, sand or sawdust)
After connecting the water inlet hose to the water tap, turn on the water tap to flush out foreign substances (dirt, sand, sawdust, etc.) in the water lines. Let the water drain into a bucket, and check the water condition.
For your safety and for extended product life, use only authorized components. The manufacturer is not responsible for product malfunction or accidents caused by the use of separately purchased unauthorized parts.
Use new hoses when you install the washing machine. Do not reuse old hoses. Use only the inlet hoses provided with the washer. LG does not recommend the use of aftermarket hoses.
Periodically check the hoses for cracks, leaks and wear, and replace the hoses every 5 years.
Do not stretch the water hoses intentionally, and make sure that they are not crushed by other objects.