Top > INSTALLATION > Disassembly > Disassembling the Washer and Dryer

Disassembling the Washer and Dryer

The washer and dryer cannot be disassembled and installed for use side by side. If it is necessary to disassemble the appliance in order to move or reinstall it, follow these instructions.

Warning

  • Protect your hands and arms from sharp edges. To reduce the risk of injury to persons, adhere to all industry recommended safety procedures including the use of long-sleeved gloves and safety glasses.

Note

  • Any damage resulting from improper disassembly/assembly or installation of the product is not covered by the product warranty.

  • Be sure to unplug the appliance.

  • Loosen screws assembled on the stack bracket on the back of the appliance.

  • Push open the caps at the left and right sides of the control panel on the front of the appliance. Loosen the screws under the caps.

  • Pull the control panel forward to remove it.

  • Disconnect the wire harnesses from the washer a and dryer b to the control panel.

    Caution

    • Always ground yourself before touching the PCB or wiring. Discharge of static electricity may cause product malfunction.

    Note

    • Tuck the wire harnesses to the side to avoid pinching them.

  • Unscrew the second screw from the top of the four screws on the left and right.

  • Lift the dryer and separate it from the washer.

    Warning

    • Protect your hands and arms from sharp edges of the panel frame exposed on the top of the washer.

    • To avoid strain injuries, use 2 or more people to lift the dryer.

    Note

    • When assembling the appliance, proceed in reverse order.