Top > MAINTENANCE > Dryer > Thawing out the Appliance

Thawing out the Appliance

Running thawing mode

  • Turn on the appliance. Press and hold the Drum Care and Anti Crease button at the same time for 3 seconds.

    Note

    • Only Power and Start/Pause buttons work when the thawing mode is activated.

    • It does not allow you to change the thawing time manually.

    • To deactivate the thawing mode, turn off the appliance.

  • Press the Start/Pause button to start the thawing mode.

    • Actual thawing time varies depending on the installation environment such as installation location and ambient temperatures of the appliance.

  • Dry the clothes as usual.

Thawing out the appliance manually

  • Open the dryer's door and pull out both inner and outer filter.

  • Pour 1 litre of hot water at 60 ℃ into the lint filter compartment and then reinsert the both lint filters.

    Caution

    • Pouring more that 1.5 litres of water into the compartment will cause water to leak back out.

    • Pouring hot water over 60 ℃ will cause malfunctions to the appliance or burn.

  • Turn on the appliance and operate the Cotton programme about for 30 seconds. Then wait about 30 minutes.

  • Operate the Cotton programme again. Check if the OE message will appear within 10 minutes after operating the appliance.

    • When the OE message appears go to step 2 and repeat procedure.

    • Nothing appears on the display when the thawing is done.

  • Dry the clothes as usual.