Choosing the Proper Location

Install the appliance on a flat and stable area floor.Cut out for hoses and electrical cables on either side. (Approximately 100 mm X 75 mm)Select a location as close to the sink as possible for ease of connection to the water and drain pipes.To ensure drainage, the appliance should not be installed more than 1 metre away from the sink.If the appliance is installed in a corner, allow minimum clearance of at least 50 mm between the appliance and an adjacent cabinet or wall.Before sliding the appliance into the installation opening, all necessary height adjustments should be made using a spanner.Any bare wood surrounding the appliance should be sealed with a waterproof paint or sealant to prevent it from swelling.Slide the dishwasher into the cabinet, opening carefully. Make sure that the drain hose behind the machine and inside the cabinet is not kinked or stretched.Install the appliance on a flat and stable area. Do not place any objects in-between the floor and base or leg off the appliance.This installation must be conducted by qualified service personnel to ensure it has been installed correctly.Do not pull or lift the appliance using the handle; doing so can damage the door and hinges. Open the door and grab the body frame and the top front opening of the tub to move or lift the appliance.Do not push the door of the dishwasher with knees.

Attaching the Strip to the Appliance Base

To reduce noise attach the strip to the appliance base.Lay down the appliance and pull on both the hooks at the bottom of the lower cover.Pull on the lower cover to remove it.Remove the double-sided tape from the lower and front strips.Attach the black coloured lower strip a to the bottom of the lower cover.Attach the lower cover with the strip onto the appliance.

Removing the Top Cover

If the height of the opening is below 850 mm, follow these instructions.Remove the 2 screws on the back.Pull the top cover backwards after removing the two screws and then lift it up to remove it.Remove the locating pins on the top by using a Phillips screw driver.