Top > TROUBLESHOOTING > Before Calling for Service > Parts & Features

Parts & Features

Oven control beeps and displays any F code error.

Cause

Electronic control has detected a fault condition.

Solution

  • Turn off the oven function you are using to clear the display and stop the beeping. Reprogram the oven. If the fault recurs, record the fault number and call for service.

k is on in the display when you want to cook

Cause

The oven door is locked because the temperature inside the oven has not dropped below the locking temperature.

Solution

  • Press the Start/Stop button on the control panel. Allow the oven to cool.

Cause

The Control Lock is activated

Solution

  • To deactivate Control Lock, refer to the Control Lock in Operation chapter.

Oven light does not work. (Model WSED7665B)

Cause

It is time to replace the bulb or the bulb is loose.

Solution

  • Replace or tighten the bulb. See "Changing the Oven Light" in the Periodic Maintenance section.

Cooling fan continues to run after oven is turned off.

Cause

The fan turns off automatically when the electronic components have cooled sufficiently.

Solution

  • This is normal.

Oven will not start Pyrolysis. (Model WSED7665B)

Cause

The oven temperature is too high to set a Pyrolysis operation.

Solution

  • Allow the appliance to cool and reset the controls.

Cause

Oven controls improperly set.

Solution

  • See the Pyrolysis in the Cleaning section. (Model WSED7665B)

Cause

A pyrolysis cycle cannot be started if the oven door is open.

Solution

  • Close the oven door.

Oven door does not open after a Pyrolysis cycle. (Model WSED7665B)

Cause

Oven is too hot.

Solution

  • Allow the oven to cool below locking temperature.

Cause

The control and door may be locked.

Solution

  • Allow about one hour for the oven to cool after the completion of a Pyrolysis cycle. The door can be opened when the lock k is no longer displayed.

The oven is not clean after a Pyrolysis cycle. (Model WSED7665B)

Cause

Oven controls not properly set.

Solution

  • See the Pyrolysis in the Cleaning section.

Cause

Oven was heavily soiled.

Solution

  • Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to do Pyrolysis again or for a longer period of time.

Convection fan stops.

Cause

Convection fan stops during a Hot Air cycle. It is done to allow more even heating during the cycle.

Solution

  • This is not a failure of the range and should be considered normal operation.