Connecting the Hose and External Filter
Applicable for Models with External Filter
Loosen the fixed nuts to connect the connector to the tap.
Untighten the screw a of the connector so that the tap can be placed in the middle, above the rubber packing b.
NoteIf the tap diameter is too large or is square, untighten the 4 screws and remove the guide plate c .
Fixing the connectors to the tap.
Push the upper connector assembly up until the rubber packing is in tight contact with the tap. Then tighten the 4 screws.
Connect the middle connector and the water supply hose.
Press down the pressing rodd of the water supply hose which was separated from the middle connector (refer to step 1) and then reconnect it to the middle connector.
Check for water leakage.
After connecting the hose, open the tap to check for any water leakage. If the connection leaks, close the tap and start again from step 1. If you skip some step, water leakage may occur.
Remove foreign substances (dirt, sand and sawdust).
After connecting the inlet hose to the taps, through the external filter, turn on the taps to flush out foreign substances (dirt, sand or sawdust) in the water lines. Drain the water into a bucket, and check the water condition.
