Drying the Water Tank and Washing the Mop
It is recommended that after each use of the mop holder, take out the mop holder from one side, empty the water tank, rinse the mop with water, and air dry it.
If you wish to completely remove remaining water from the water tank, use the following additional guidelines. This is recommended if the mopping function is not used daily.
With the water tank in an upright position, attach a paper towel or a cloth to the outlet and remove remaining water.
Remove as much water from the water tank as possible, tilt the water tank towards the water tank stopper so as to collect the water, and then dry it by laying it upside down on a paper towel or a cloth.
Do not use the mopping mode on any carpet.
When the robot cleaner is being charged or idle, please remove the mop holder.
In order to achieve better mopping results, it is recommended to sweep your floor three times with the robot cleaner before installing the mop holder.
To avoid damaging your wood floor, please make sure to take out the mop holder immediately after floor mopping is complete. Or install the home station onto the Floor Protector Plate (optional).
When mopping is paused or finished, the robot cleaner will automatically cut off the water to the mop pad. However, the mop remains wet and should not be left attached as it can case odors.